By: Steve
Ok Blogadmin thanks very much for the time and support. I figured out what the problem was. When configured as it should with the correct acl for the crypto map, the vpn stayed down until I generated...
View ArticleBy: Aline
I would like to know if someone already configured a VPN with two links balanced. How can I configure if the interfaces were FastEthernet, because I can´t configure multilink and I´ll have two ip...
View ArticleBy: Dave
There should not be any problem to configure VPN if the two interfaces were fastethernet
View ArticleBy: Kunal
I have followed this guide as well as several others and setup both my routers according to them but for some reason I cannot see any connection when I do show crypto isakmp sa. I have tried sending...
View ArticleBy: Kunal
This is the config for the above mentioned question: version 12.3 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname Router_A ! boot-start-marker...
View ArticleBy: Blog Admin
In reply to <a href="https://www.networkstraining.com/lan-to-lan-ipsec-vpn-between-two-cisco-routers/#comment-2272">Kunal</a>. My friend you have not followed exactly the configuration as...
View ArticleBy: Kunal
Admin, Thanks for the quick reply. I would like to say I am brand new to Cisco IOS so please forgive my stupidity (past or future). I added the entry on both routers and still have no activity. The...
View ArticleBy: SamAwatif
Man Many Many Thanks, I was Confused as to how to go about Allowing IPsec Tunnel While using NAT Since IPsec traffic can’t be natted, I’ve read other blogs but coudn’t get my head around it :-( but...
View ArticleBy: Gagan
im very new to cisco Can you help me on this i have to configure site to site vpn with 2 cisco router. Router A using ADSL internet connection (Dynamic IP Address, ADSL modem lan port connected to fe0)...
View ArticleBy: Blog Admin
In reply to Gagan. Gagan, Although its not officially supported to have ipsec vpn between two dynamic-IP peers, see the following link which might help you. https://supportforums.cisco.com/thread/343363
View ArticleBy: Tim
Hi i followed the instructions, once i got UP-Idle, once i cleared the session the status went from negotiating to DOWN and i keep getting: No peer struct to get peer description can you please shed...
View ArticleBy: Blog Admin
In reply to Tim. Tim, This might have to do with your VPN ACL which is applied in the crypto map. The two VPN ALCs on the two sites must be exactly mirror of each other. Post the config here to take a...
View ArticleBy: Tim
In reply to Blog Admin. Hi Harris, Thanks, for the quick replay, even Cisco Tac wouldn’t had responded so fast :) I’m sure your way works well, but after going back and forth all day, i chose a...
View ArticleBy: Blog Admin
In reply to Tim. Yeah, using the VTI with IPSEC is a good option as well (VTIs are very flexible also)….good luck Harris
View ArticleBy: J B
!–add another site to ROUTER-A (assumes you use the same interface w/multiple vpns) !– this additional site (ROUTER-C) has a WAN IP 300.0.0.1 LAN IP 192.168.3.0/24 !– (note: you can use a new key if...
View Article